Installation and Welding of GRP Pipe System course
May 15 - May 19\ 2022 : London
May 09- May 13 \ 2022 : Istanbul
July 17 – July 21 \ 2022 : Kuwait
July 17– July 21 \ 2022 : Oman
September 04 – September 08 \ 2022 : Amman
October 02 - October 06 \ 2022 : London
Ø INTRODUCTION |
The correct installation of the pipes requires individual calculations and comprehensive planning by certified engineers. In addition to the applicable standards and guidelines, the requirements for each installation and the operating conditions for each project shall be evaluated by engineers. generally verify the installation conditions on site, which hence is in the responsibility of the contractor or consulting engineer. The installation of GRP Pipes, the relevant standards and guidelines such as EN 1610 and ISO/TS 10465-1 apply. IACT Course offers custom services based on individual advice. For special conditions requiring specific approaches
|
Ø Objectives |
At this program's conclusion, participants should be able to:
l GRP set up and maintenance l GRP failures l GRP manufacturing l GRP joining menthods l GRP installation l GRP welding |
|
Ø TRAINING METHODOLOGY |
This interactive training course includes the following training methodologies as a percentage of the total tuition hours: l 30% Lectures, Concepts, Role Play l 30% Workshops & Work Presentations, Techniques l 20% Based on Case Studies & Practical Exercises l 20% Videos, Software & General Discussions Pre and Post Test |
|
Ø WHO SHOULD ATTEND? |
l oil and gas inspector l Pipe inspector l Civil Engenering |
Outline |
|
Day 1 |
l GRP Family l Characteristics of GRP l What are the advantages of GRP l Types of Manufacturing of GRP Pipes |
Day 2
|
l Polyester Resins l Isophthalic Polyester l Bisphenol A Polyester l Chlorinated polyester |
Day 3
|
l Vinyl ester resins l Epoxy resins l Reinforcing materials l Codes and Standards l GRP Pipes and Fittings |
Day 4 |
l Jointing methods l Adhesive Joint l Flange Joint l Lamination Joint l Rubber Seal Lock Joint
|
Day 5 |
l Installation Inspection l Applications l GRP Failures l Metallic-GRP interface l Supporting Aspects l List of Relevant Standards,Design & Calculation Basis l International Standards, Design & Calculation Basis l Standards, Design & Calculation Basis, Malaysia |
Schedule
- 08:30 – 10:15 First Session
- 10:15 – 10:30 Coffee Break
- 10:30 – 12:15 Second Session
- 12:15 – 12:30 Coffee Break
- 12:30 – 14:00 Third Session
- 14:00 – 15:00 Lunch
Fees
The Fee for the seminar, including instruction materials, documentation, lunch, coffee/tea breaks & snack :